#Rad racing r6 frame slider hex bolts install#

#Rad racing r6 frame slider hex bolts install#

You won’t need to install the panel screws at this point, you just need to get an idea of the bracketĪlignment. The panel has locking tabs on the back that must be engaged by sliding it toward the rear of Tighten the screw only slightly, so the bracket can be moved and adjusted by hand.ĥ. To confirm, the correct screw has a fine thread pitch and should thread in by hand or with very little force. Install the bracket with the correct screw. One is to be installedīeneath the offset bracket (between the bracket and frame), and the other is used with the bracketĤ. Notice: Two washers are shipped on the left side slider offset bracket screw. You will damage either the threads in the engine or the bracket if the screws are swapped.

The two screws have different threads and Screw that holds the bracket to the engine mount swapped. Important not to get the screw that holds the slider to the bracket (the one you just removed), and the Remove pre-installed slider from bracket and install the bracket using the supplied screw. Remove the screw with your 12mm socket and ratchet.ģ. Locate the engine mount screw- its chrome plated (12mm head) and runs through the frame and into the engine. Must be disengaged- do this by sliding the panel forward.Ģ. The panel also has locking tabs on the back that Pushing in on the center of it with the small pointed screwdriver.

Pin is located on the inner part of the panel near the aluminum part of the radiator hose and can be removed by Start on the left side by removing the fairing panel- this has four Allen head screws and one push pin. Install one side at a time- do not remove both engine bolts together.ġ. WARNING: The installation of all parts in these installation instructions must be performed by a qualified motorcycle mechanic who is using the correct tools and who understands the correct use of all tools required to complete the installation. 2006-2007 Yamaha R6 Installation Instructions for: